Hot Water Booster Coils Tag

Steam Distributing Coil

There are many terms used in the HVAC Industry. One that is often misunderstood is heat transfer. Wikipedia’s definition states that heat transfer is a thermal engineering discipline that concerns the generation, use, conversion, and exchange of thermal energy between physical systems. It affects the measurement of heat.   The various heat transfer types are thermal conduction, thermal convection, thermal radiation, and the transfer of energy...

Read More
Steam Distributing

The “holiday season” may be over, but the “coil replacement season” is in full swing in many areas of the country. Particular attention must be paid to the condition of your heating and cooling coils. Heating coils that aren’t providing the needed BTUH capacity can become a huge problem in the dead of winter, while cooling coils and condenser coils must be ordered and replaced...

Read More
Hot Water Coil

The HVAC industry has many manufacturers of units that all have heating and/or cooling coils as an integral part of their package. There are also many free-standing coils in large built up systems and some are mounted in duct runs from a central station unit. What they all have in common is the presumption that all the coils will meet the designated performance. They do...

Read More
Condenser

  Almost all packaged A/C or split system units do not have a service factor for extra capacity. Even when new, these units may not yield the cooling BTUH capacity specified due to improper installation and/or incorrect load calculations at the inception of installation and startup. Consequently, as the system gets older and parts become less efficient, the system may lower its capacity to the point...

Read More
Duct Booster Coil

There are many existing systems that require the addition of cooling to a heating-only unit. Systems need to keep pace with changing requirements for spaces that include a mandatory requirement for cooling. Existing systems can already have cooling, but a booster will have to be placed into the system to add additional cooling.   When cooling is added, it must be decided whether the tonnage can be...

Read More

Most HVAC steam heating coils operate with steam pressure below 25 PSIG, and a very large percentage are below 15 PSIG. These coils have specific piping and coil arrangement requirements to allow these systems to optimize performance and avoid systematic problems that require premature replacement.   Preheat coils in most of the country will require an arrangement that deals with below freezing air temperatures. In conjunction with...

Read More
Sentry Guard

Operating water coils that are prone to air temperatures below freezing normally need the use of anti-freeze. The most common is glycol. This has been used for over 40 years, and there are two common types, ethylene and propylene. Anti-freeze provides a safeguard if there are mechanical or electrical breakdowns that may cause fluid to sit in a coil with below freezing air going across...

Read More
Dirty Coil

Finned tube coils are meant to have contact with the air flow, as more contact creates more heat transfer. Heat transfer is nothing more than heat exchanged from one medium to another, and the goal is to create maximum heat transfer efficiency. The downside to this process is the coil’s susceptibility to foreign materials becoming lodged in them. The following explores this problem in a...

Read More
Booster Coil

Many projects require downstream duct mounted coils to heat or cool air to its final desired temperature. Normally there are upstream coils that regulate the leaving air temperature to a design intermediate level. The duct coil takes the air from that intermediate level to its final desired temperature. Many systems can vary the air flow or water volume to achieve a desired leaving air temperature...

Read More
Outside Air Loads

HVAC and process heating/cooling must deal with the added tonnage created by using fresh air from outside. Most times, the requirement for fresh air is mandatory and can go from 10% all the way to 100 % of the system air flow. There are numerous rules and regulations written to eliminate air flow quality problems, including bacteria and other micro-organisms, that can cause health problems....

Read More